Like previously said, either just fiddle with cursor starting and end positions to try and get as much movement as you can to let the clamp lock to end point and not bounce back.ĭoing the slide as far as you can then quickly regrab the clamp worked but it took a lot of tries to get the timing right. one last time and join Leonardo da Vinci, the master of both art and science, as his friend and apprentice. Inside of yuzu click File -> Open yuzu folder. The House of Da Vinci 3D Room escape game. There click Emulation -> Configure -> System -> Profile Then press on Add and make a new profile, then close yuzu. I think it's probably just a flaw from the porting. Open it in WinRar, 7ZIP idk and then move the contents in a folder and open the yuzu.exe. THE STORY Become Giacomo, the apprentice to the Renaissance genius, Leonardo da Vinci. Join more than 1.000.000 players from around the world and dive into the 3D puzzle adventure with an outstanding rating of 4.8/5. Originally posted by Obamanation:I initially had this same problem, it seemed like you just couldn't move the clamp far enough to lock, no matter where you started with the mouse cursor. The long awaited sequel to The House of Da Vinci is finally here. Idk if this is intentional design (to grab clamp again before it fully resets), or just flaw from porting from touchscreen. Enter The House of Da Vinci, a new must-try 3D puzzle adventure game. It seemed like i was able to grab the clamp before it fully reset to initial position, which gave me the leeway to get the last bit of distance to make it lock into final position. Nintendo Switch The House of Da Vinci This item will be sent to your system automatically after purchase. I moved the clamp at the max range of motion i could, then released clamp, quickly moved mouse back to grab clamp again before it reached initial position, then moved clamp back to max range of motion to lock into place. Like previously said, either just fiddle with cursor starting and end positions to try and get as much movement as you can to let the clamp lock to end point and not bounce back.įor my personally, idk if this is what actually happened, but it seemed like it. I think it's probably just a flaw from the porting. I initially had this same problem, it seemed like you just couldn't move the clamp far enough to lock, no matter where you started with the mouse cursor.
0 Comments
Leave a Reply. |